The "Credit-Control-Answer" Diameter command code

The "Credit-Control-Answer" Diameter command uses the command code "272".

It has the PXY bit.

It is part of the 3GPP Gxx, Diameter Credit Control Application, 3GPP S9, 3GPP Gx, 3GPP Re/Rf, 3GPP S9a, 3GPP S9a*, 3GPP Sd, 3GPP S15, 3GPP St, 3GPP Gx over Gy, 3GPP Gx applications.

It is defined in the 3GPP TS 32.296: Telecommunication management; Charging management; Online Charging System (OCS): Applications and interfaces specification.

It contains the following AVPs:

< Credit-Control-Answer > ::= < Diameter-Header: 272, PXY > 
< Session-Id >
{ Result-Code }
[ DRMP ]
{ Origin-Host }
{ Origin-Realm }
{ Auth-Application-Id }
{ CC-Request-Type }
{ CC-Request-Number }
[ Experimental-Result ]
[ User-Name ]
[ CC-Session-Failover ]
[ CC-Sub-Session-Id ]
* [ Supported-Features ]
[ Accounting-Multi-Session-Id ]
[ OC-Supported-Features ]
[ Origin-State-Id ]
[ OC-OLR ]
[ Event-Timestamp ]
* [ QoS-Rule-Install ]
* [ Charging-Rule-Install ]
[ Granted-Service-Unit ]
* [ QoS-Rule-Remove ]
* [ Charging-Rule-Remove ]
* [ Multiple-Services-Credit-Control ]
* [ QoS-Information ]
[ Event-Report-Indication ]
[ Framed-IPv6-Prefix ]
[ Cost-Information ]
[ Bearer-Control-Mode ]
[ Final-Unit-Indication ]
[ Low-Balance-Indication ]
* [ Event-Trigger ]
[ Check-Balance-Result ]
[ QoS-Final-Unit-Indication ]
[ Remaining-Balance ]
[ Charging-Information ]
[ Credit-Control-Failure-Handling ]
* [ Subsession-Decision-Info ]
[ Direct-Debiting-Failure-Handling ]
* [ CSG-Information-Reporting ]
[ Validity-Time ]
*2 [ AN-GW-Address ]
* [ ADC-Rule-Remove ]
* [ Redirect-Host ]
* [ ADC-Rule-Install ]
[ Redirect-Host-Usage ]
[ Error-Message ]
[ Online ]
[ Redirect-Max-Cache-Time ]
[ Error-Reporting-Host ]
[ Offline ]
* [ Proxy-Info ]
[ 3GPP-User-Location-Info ]
* [ Route-Record ]
[ Revalidation-Time ]
* [ Failed-AVP ]
[ Default-EPS-Bearer-QoS ]
[ Restart-Counter ]
* [ Load ]
[ Default-QoS-Information ]
[ Bearer-Usage ]
* [ Usage-Monitoring-Information ]
[ Service-Information ]
[ User-CSG-Information ]
[ PRA-Install ]
[ PRA-Remove ]
[ Presence-Reporting-Area-Information ]
[ Session-Release-Cause ]
[ NBIFOM-Support ]
[ NBIFOM-Mode ]
[ Default-Access ]
[ RAN-Rule-Support ]
* [ Routing-Rule-Report ]
*4 [ Conditional-Policy-Information ]
[ Removal-Of-Access ]
[ IP-CAN-Type ]